Motorcycle wire harness wholesalers suggests when stripping the wire, the stripping length must be moderate. If the stripping is too short, the wire can not be inserted into the conductor crimping area when the terminal is crimped. The crimping force between the terminal and the wire can not meet the requirements of the tensile test, and it is easy to run on the locomotive. Process vibration causes the wire to fall off. Since the wires and terminals are in contact with the metal, the heat is severe here and an open circuit may occur. In this regard, a sufficient strip length should be strictly ensured, and the wire should be inserted into the crimping area as much as possible during crimping.

Cable inserted too deep

In contrast, if the wire is inserted too much to enter the transition zone. Due to the long wire core, the pins may not be properly inserted, causing poor wire contact between the two connectors, resulting in signal interruption. Another type of fault often occurs because the wire is inserted too long, causing the two lines to be short-circuited. The locomotive traction motor speed sensor connector is caused by multiple accidents. The way to eliminate such quality problems is to strictly limit the length of the stripping wire not to be too long, and to maintain a proper amount of wire insertion when crimping the wire. If you want to learn more about best quality double needle bar raschel knitting machine,you can contact us.