Car chassis wire harness from China

In order to make the whole vehicle line regular, easy to install and protect the insulation layer of the wire, in addition to the high-voltage line, battery, cable and starter cable, the whole vehicle line on the car will generally be similar to the different plans of the same area in the same area with cotton yarn or Bo The polyvinyl chloride tape is wound and wrapped into a wire Car chassis wire harness.

Harness composition

Car chassis wire harness from China is generally composed of wires, terminals, connectors, protective covers and various accessories. Segmented harnesses are now commonly used, which are easy to replace and less expensive.

Wiring harness and installation precautions

1. Binding of the wire harness:

a. The cable is half-stacked, coated with insulating paint, and dried to increase the strength and insulation of the cable.

b. The new type of wire harness, after the local plastic is wrapped, put into the plastic corrugated pipe of the side cut, so that the strength is higher, the protection performance is better, and it is convenient to find the line applause.

2. Installation of the wiring harness:

After the wiring harness of the same model is designed and manufactured according to the model in the manufacturer, it is fixed at the predetermined position on the vehicle with a circlip or a nail. The tap is just near the terminal of each electrical equipment, and it is installed according to the line number during installation. Corresponding to the binding posts. The harnesses of the various models are different, and the harness of the same model is divided into multiple harnesses according to the engine, chassis and body.