Motorcycle wire harness wholesalers will introduces the wire and connector open circuit,Wire and connector open circuit failure may be caused by broken wires during use, poor connector contact, and loose connector terminals.

Since the failure of the wire to break in the middle is very rare, most of them are disconnected at the connector. Therefore, the inspection should focus on carefully checking the sensor and the wire connecting the cable, if there is looseness and poor contact.

The connector open circuit failure caused by poor contact is often caused by corrosion of the connector end, external dirt entering the terminal or connecting to the socket, thereby causing a decrease in contact pressure. At this point, just remove the connector and reinstall it to change its connection and return it to normal contact.

Wire and connector short circuit failure

Failure of the wires and connectors may also be caused by a short circuit between the harness and the body (ground) or within the associated switch. Before the inspection, first check whether the wire connector of the body is fixed firmly, and then follow the steps below to test. If you want to learn more about transmission wire harness made in China,you can contact us.