Changzhou Taixu Auto Parts Co., LTD.

What is the common process of custom wiring harness?

From:Changzhou Taixu Auto Parts Co., LTD.     Release time:2019-09-16 21:55

What is the common process of custom wiring harness? Let’s briefly introduce

 

First, stripping the line, first check whether the machine table and the knife edge are normal, whether the table top is clean, and then stripping work.

 

Second, riveting terminal: need to pay attention to whether the riveting tension is in line with the requirements, not flying wire, terminal deformation.

 

Third, the assembly of the plastic shell: after the above work is completed, the direction is fixed in the same direction as the shell card.

 

Fourth, test, test whether power is on, whether short circuit and leakage, etc.

 

Fifth, the package can be shipped out of the library.When wiring harness processing, you must first China,you can contact us.

 

 

Message BoardPlease write down your question and we will respond to you within 24 hours.
Note: the maximum input of 500 characters!